This site uses cookies. You can change this in your browser settings (Privacy policy). close
Stationary tribunes with plastic seats - for indoor use
  • Stationary tribunes with plastic seats - for indoor use

Stationary tribunes with plastic seats - for indoor use

14-51 - 14-57
VAT included

Segmental stationary demountable sports tribunes with plastic seats, intended for use in sports halls, certified for compliance with PN-EN standards

Quantity
mail_outline Ask a question

Stationary tribunes with plastic seats - for indoor use


Intended: for indoor use
 
Basic features of the system:
  • Certificate of compliance with EN-PN 13200 standards
  • Steel structure, powder coated
  • Modern design and high aesthetic
  • Individual design - the ability to adapt to each facility
  • Safe platforms made of non-slip plywood

Material and technical specification:

Axial spacing of seats 500 mm
Type of seats Plastic seat without backrest H=11 cm
Plastic seat with medium-high backrest H=25 cm
Plastic seat with high backrest H=32 cm
Level difference between platforms 280 mm
The height of the middle steps 140 mm
Steps finishing Anti-slip corrugated metal sheets
The width of the entrances >120 cm
Metal surfaces finishing Powder coating by the RAL palette
As a standard light gray RAL 7035
Handrails colour As a standard RAL 7035 or in the colour of the structure
Material of the platform Anti-slip plywood, finished with decorative profile
Maximum loading According to the standard PN-EN 13200-1

The number of rows / Parameters 2 3 4 5 6 7 8
The depth of the tribune [cm] 125 210 295 380 465 550 635
The height of the last platform [cm] 28 56 84 112 140 168 196
Average number of seats per 1 m * ~3,5 ~5 ~6,5 ~8 ~9,5 ~11 ~12,5

* Average number of seats listed in the table may differ from the actual value in the finished project, due to local conditions, layout of seats, number of entrances, etc.

General information
Stationary tribune for indoor use, with plastic seats and platforms made of anti-slip plywood finished with decorative profiles.

The structure of the tribune is made of closed steel profiles (transverse frames, connectors, brackets for attaching seats) and hot rolled metal sheets 1,5 mm thick, bent in a special shape, powder coated to any color in the RAL palette (as a standard RAL 7035 – light gray). The frames are mounted in standard spacing of 2000 m or 1500 mm.

Hard to ignite plastic seats available in three types: without backrest, with medium-high backrest and with high backrest. The tribune is equipped with safety handrails, installed at the rear and at the sides, powder coated.

The design of the tribune is customize for particular facility, according to the safety directives concerning tribunes.

Length of the tribune - depending on the required number of seats and rows, or conditioned by restrictions in the development of the area.

In order to obtain full information, please contact the Technical and Trade Department.

14-51 - 14-57